Posted: Thu Jul 29, 2010 9:38 am Post subject: Using the Chain Start for tubular-circular nets
Using the chain start for circular or tubular nets is discussed in the "chain start" thread. I am indebted to Mr. Willy Landham of the Abaco.com forum for pointing out this technique. Thanks
Leave a tail at 3 times the length of the tube you desire to make. Make the chain. Closing the chain adds ONE mesh to the total. Bring end of chain around so that WE is on the left Tie into A, and then B.
Note that when you tie into B you tie like a left handed person so that the WE comes out in the proper direction,. (this is not critical)
Now the Working end is on the left and the tail is on the right. Tie the drop knot and begin the next row. The anchor (support cord) goes through the meshes on the inside of the circle. Tony
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
